AMCOwner’s Manual720760800900THX
105) Place the speaker into the rough opening.6) Level the speaker and tighten the screws, being careful not to over tighten them. Seediagram below fo
11LIMITED WARRANTYFor five years from the date of purchase, Snell Acoustics will repair for the original owner anydefect in materials or workmanship t
300 Jubilee Drive, P0B 3717Peabody, MA 01961-3717phone: 978-538-6262fax: 978-538-6266email: [email protected]©2002 Snell
2SPECIFICATIONSFrequency Response (±3dB)Recommended AmplifierNominal ImpedanceSensitivity (2.83v at 1m)Tweeter(s)MidrangeBass DriverCrossover PointCom
3AMC80065 Hz-20 kHz10–200W4 ohms90dB SPL1” Aluminum dome, ferrofluid coolingand heatsink. Steerable “DirectedPower” waveguiden/a61/2-inch (165mm) copo
4INTRODUCTION: WHAT IS A HIGH END IN-WALL?The new Snell AMC series units bring a novel approach to the design and construction ofin-wall loudspeakers,
5PLACEMENT OF THE FRONT CHANNEL SPEAKERSA home theatre system includes three loudspeakers placed across the front of the listeningroom. The distance b
6If two surrounds are used in a standard 5.1 configuration (not 7.1 or EX), they are best mountedto the sides of the listening area. This means straig
7AIMING THE DPT (AMC720, AMC 760 and AMC800 only)In addition to providing an extremely clean wide range response, the DPT have the addedfeature of an
8Setting the Dispersion SwitchThe illustrations below show the recommended Dispersion Switch setting for most commonplacement options for the AMC 800.
9PREPARING FOR INSTALLATIONMap out the wiring paths from the speakers to the amplifier. We recommend 16-gauge wire forruns up to 25 feet, and 14-gauge
Kommentare zu diesen Handbüchern